Call nowGet Estimate!

Wood Flooring Free Estimates: 954.663.8000

Le’ts Fix Your Squeaky Wood Floors

A squeaky floor signifies an older home with noisy spaces that need attention. Home buyers rarely prize floor squeaks. Even established homeowners may find that enough is just enough: the problem has gone on for too long. Fortunately, you can repair squeaky floors with simple techniques that are much easier than tearing up the floor and re-installing it.

What Causes Floor Squeaks?

Before jumping into repairs, it helps to understand what causes squeaks. Friction is the underlying reason. All floor squeaks can be traced to two flooring elements rubbing against each other, such as:

  • Nails or staples that are no longer holding the floorboard tight and are now rubbing through the hole in the floorboard
  • Two floorboards rubbing against each other
  • Subfloor fasteners pulling in and out of the underlying joist
  • Metal ductwork rubbing against the hole in the flooring that brings the duct up to floor level
  • Uneven or bowed joists rubbing against the subfloor

Stopping the friction stops the squeaks. In most cases, this means physically controlling those two elements and preventing at least one of those elements from moving.

Repairing Squeaks From Below

When you have access to the underside of your flooring from a crawlspace or basement, the repair will be easier and, in most cases, invisible. If this is a finished space and there is a ceiling, you may want to assess whether the time and effort involved with removing and replacing part of the ceiling to gain access will be more beneficial than doing the repair from above. Drywall removal is messy and replacement equally so. On the other hand, the project is relatively low-cost, straight-forward, and ensures that you will get to the heart of the noisy floor problem.

First, have someone from above step on the squeaky spot, while you pinpoint its location from below. Mark the spot with a square of removable painter’s tape. Next, try any number of these repairs, beginning at the top, combining as needed:

  • Tap a wood shim between the joist and the floorboard or subfloor. If this works, remove the shim, coat with wood glue, and insert again. Force in the shim only far enough to stop the squeak.
  • While wood shims separate flooring materials, a product called Squeak-Ender does the opposite: it pulls flooring layers together. This avoids any bowing effect that shims might cause and effectively brings the layers back to their true state.
  • Bent, twisted, and otherwise malformed joists can be cured by sistering a two-by-four along the joist, butted up against the subfloor or floorboards.
  • Run a long bead of construction adhesive in the seam between the joists and the floorboards or subfloor.
  • Sometimes lateral control is just as important as vertical control. If your joists lack blocking or the current blocks may not be doing their job, cut two-by-eight boards to fit between the joists’ midpoints, tap into place, then hammer into the joists with nails.

Repairing Squeaks From Above

    When you do not have access to the bottom side of the flooring or if gaining access proves to be too difficult, you have a few options for top-side repairs of floor squeaks.

  • If you have solid hardwood or engineered wood floorboards, the squeak might be caused by the floorboards rubbing against each other. Squirt powdered graphite between the boards, then lightly rub the product into the seams with a soft brush or cloth. Vacuum up the excess.
  • Decreased humidity levels dry out wood flooring and accentuate squeaking. Adding a humidifier to gently raise the room’s humidity may eliminate the squeaks.
  • Pull back the floor covering to access the subfloor. Wall to wall carpeting, edge-stapled resilient flooring, and floating floors can be pulled up since they are only minimally attached to the subfloor. Then locate the joists and drive 1-inch screws through the subfloor and into the joists near the problem areas.
  • For easy low-mess squeak relief, O’Berry Enterprises’ Squeeeeek-No-More-Carpeted Floors and Squeeeee-No-More-Wood Floors offers a patented system of scored screws that snap off near the head after you have finished sinking them.
  • For hardwood or engineered wood floors, drill a pilot hole at an angle through the floorboard, directly above a joist. With a hammer, nail a 1-inch finish nail through the pilot hole. Countersink the nail with a nailset. Cover the tiny hole with matching wood filler.
  • For carpeting that cannot be pulled back, separate the carpet fibers to expose an area about 1/4-inch in diameter. If necessary, cut back a few fibers with a utility knife to excise just enough fibers to expose the area. Drive a 1-inch screw through the area until the head of the screw is flat with the carpet backing. Comb back the carpet pile with your fingers to cover up the area.

Trackback from your site.

admin

This information box about the author only appears if the author has biographical information. Otherwise there is not author box shown. Follow YOOtheme on Twitter or read the blog.

Leave a comment

You must be logged in to post a comment.

Licensed and Insured

Face of Wood is Licensed and insured, so you can have peace of mind when hiring our services.

FEI/EIN Number: 261379255
Broward County: CC#10-FC-16770-X
West Palm Beach: #U-21591
Miami Dade: #11BS00221
Martin County: MCNS6372

Face of Wood’s Awards

Face of Wood has been awarded the Angie’s List Super Service Awards for 3 years in a row.

Financing Available

We have Financing available for our customers, through Synchrony Finance. Details

Privacy Policy

We respect your privacy. Any and all information collected on this site will be kept strictly confidential and will not be sold, disclosed, or loaned!

Any information you provide will be held with the utmost care and will not be used in ways that you have not consented to. If you have any questions, please feel free to call or e-mail us.

Click Here to Read Our Privacy Policy

Connect to Face of Wood

You can connect and get in touch with us using any of the following social media or pages:

| | | | | |

Hours of Service

Monday to Friday: 8:00 am to 5:00 pm
Saturday: 9:00 am to 3:00 pm
Sunday: Closed